SMR Gearbox Installation
Satisfactory effectiveness relies on appropriate installation. lubrication and maintenance. therefore it is vital that the guidelines within the set up and servicing leaflet. provided with just about every gearbox. are followed carefully. a few of the significant facets of belt and torque-arm set up are listed below.
1. Install pulley on gearbox input shaft as near to your reducer feasible, and mount reducer on driven shaft as near to bearing as practical. failure to carry out this can trigger excess loads inside the input shaft bearings and output bearings and could result in their premature failure.
two. Install motor and 
wedge belt drive using the belt pull at approximately 90° towards the center line concerning driven and input shafts. this will permit tensioning in the wedge belt drive using the torque arm which need to preferably be in stress. if output hub runs anti-clockwise. torque arm should be positioned the ideal.
three. lnstall torque-arm fulcrum on a rigid assistance to ensure the torque-arm will probably be at around suitable angles to your center line through the driven shaft along with the torque arm case bolt. make sure there is certainly ample get up inside the turnbuckle for belt tension adjustment.
Preserve close.
Bell drive might be found in any handy postion. in case the torque arm is always to be applied to tighten the belts, the drive really should be at about tight angle to the line amongst the input and output shafts.
Bell drive may be found on the right if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that proven during the illustration.
Torque arm and belt consider up.
Torque arm could be mounted to your ideal if wanted.
